XBee Interface Module - Technical Info

Specifications

* Small size only 2.5" x 2"

* 18F4321 processor

* Interface using Phoenix terminal blocks (1984691)

* Mounting holes 0.130" (3.3mm or #4 screws)

* TTL level serial interconnect (optional)

* XBee factory reset jumper

* XBee forced addressing jumper

* User programmable using the Microchip PICKIT or compatible programmer

* Pads for optional connectors on back side for daughter board

* No code required ! Fully functional command interface embedded in the processor.

Jumper Block Functions

Reset will force the XBee to factory values in the event the module has been mis-configured.

CFG forces the DL value to 0xFFFF as a special configuration address to setup the module for your network requirements. This ensures it will not interfere with other reset modules.

Both of these are only valid on a power cycle, and once configured the jumpers should be removed for normal operation on the next power cycle.

The PICBEE can be used as an interface to the XBee radios or as a stand alone target. Adding the connections for the serial interface provides access to the PIC's internal UART. Custom firmware for your particular application creates a powerfull yet compact solution to many applications.